ASME A112.19.5:2005 pdf download.Trim for Water-ClosetBowls, Tanks,and Urinals. 2 DESIGN REQUIREMENTS Thread dimensions shall be as given in Tables 1 and 2. The information provided in Nonmandatory Appendix A is the result of a series of ca...
ASME 2022-09-26 1
ASME A112.19.16:2006 pdf download.Terrazzo Plumbing Fixtures. 2 GENERAL REQUIREMENTS 2.1 Material 2.1.1 Terrazzo. The cast-stone terrazzo composition shall be composed of fine and coarse mineral aggregate and Portland cement or other suitab...
ASME 2022-09-26 1
ASME A17.5:2019 pdf download.Elevator and escalator electrical equipment. 16.13 For a pilot light consisting of a lampholder in series with a dropping resistor or connected to an autotransformer, the spacings shall be a) not less than 1.2 m...
ASME 2022-09-26 1
ASME A17.5:2004 pdf download.Elevator and escalator electrical equipment. 4 Enclosure construction 4.1 General 4.1.1 The enclosure of control equipment shall be constructed and assembled so that it will have the strength and rigidity necess...
ASME 2022-09-26 1
ASME A17.4:2015 pdf download.Guide for Emergency Personnel. 1.2.2 Training and Instruction The rescue team should be given training in the proper procedures for evacuating passengers as required by ASME A17.1FCSA B44, requirement 8.6.11.5.4...
ASME 2022-09-26 1
ASME A17.4:1999 pdf download.Guide for Emergency Personnel. 1.3.1 Communication Prior to conducting an evacuation, the following steps should be taken. (a) The responsible personnel in the building should immediately communicate with the oc...
ASME 2022-09-26 1
ASME A17.6:2010 pdf download.Standard for Elevator Suspension, Compensation, and Governor Systems. 1.3.4.2.5 ResIdual Strength. The actual breaking strength of a suspension member at any time during its operatonal life cycle. NOTE: The resi...
ASME 2022-09-26 1
ASME B16.9:2003 pdf download.FACTORY-MADE BUTTWELDING FITTINGS. 6.2.1 Fatigue Loading. For applications where fatigue loading is a concern, required minimum dimensions shall be furnished by the purchaser. 6.2.2 Boie Diameter. Bore diameters...
ASME 2022-09-26 1
ASME B16.5:2013 pdf download.Pipe Flanges and Flanged Fittings NPS 1/2 Through NPS 24 Metric/Inch Standard. 5 MATERIALS 5.1 General (a) Materiak required for flanges and flanged fittings are li%ted in Table IA with the restriction that plat...
ASME 2022-09-26 1
ASME B16.4:2021 pdf download.Gray Iron Threaded Fittings Classes 125 and 250. (c) For the purpose of easier entrance in making a joint and for protection of the thread, all threads shall be countersunk a distance of not less than one-half t...
ASME 2022-09-26 1