ASME B16.24:2006 pdf download.Cast Copper Alloy Pipe Flanges and Flanged Fittings Classes 150,300,600,900,1500, and 2500. 1.4 References Codes, standards, and specifications, containing provisions to the extent referenced herein, constitute...
ASME 2022-09-27 1
ASME B16.23:2016 pdf download.Cast Copper Alloy Solder Joint Drainage Fittings: DWV. 10.3 Ovality Maximum ovality shall not exceed l’, of the masimum diameters shown in Table 2 or Table 1-2. The average of the maximum and minimum diameter...
ASME 2022-09-27 1
ASME B16.22:2021 pdf download.Wrought Copper and Copper Alloy Solder-Joint Pressure Fittings. 10.3 Design of Threaded Ends The wrenchrng section of internally threaded ends shall be polygonal or bead with or without ribs, and the wrenching...
ASME 2022-09-27 1
ASME B16.22:2018 pdf download.Wrought Copper and Copper Alloy Solder-Joint Pressure Fittings. 9 INSPECTION TOLERANCE 9.1 Convention For determining conformance with this Standard, the convention for fixing significant digits where limits (m...
ASME 2022-09-27 1
ASME B16.22:2012 pdf download.Wrought Copper and Copper Alloy Solder-Joint Pressure Fittings. The largest opening in the fitting shall govern the tolerance to be applied to all openings. 9.3 Ovallty of Fitting End (C or FTG) Maximum ocality...
ASME 2022-09-27 1
ASME B16.22:2001 pdf download.WROUGHT COPPERAND COPPER ALLOY SOLDER JOINT PRESSURE FITTINGS. (b) Other coppers and copper alloys are permitted. provided they med the chemical requirements of minimum copper and I maximum iinc. and provided t...
ASME 2022-09-27 1
ASME B16.21:2021 pdf download.Nonmetallic Flat Gaskets for Pipe Flanges. 2.7 Pressure Class Designation Class, followed by a dimensionless number. is the designation for common flange pressure-temperature ratings as given by the referenced...
ASME 2022-09-27 1
ASME B16.21:2011 pdf download.Nonmetallic Flat Gaskets for Pipe Flanges. 2.1 Relevant Units This Standard states values both in SI (metric) and U.S. Customary units. As an exception, diameter of bolts and flange bolt holes are expressed in...
ASME 2022-09-27 1
ASME B16.21:2005 pdf download.Nonmetallic Flat Gaskets for Pipe Flanges. 5 MARKINGS 5.1 MaterIal Marking Unless otherwise specified by the purchaser, gasket material shall be marked with the material manufactuner’s nanw or trademark and m...
ASME 2022-09-27 1
ASME B16.20:2017 pdf download.Metallic Gasketsfor Pipe Flanges. SW-2.6 Performance Testing For all corresponding sizes and pressure classes, finished gaskets (including windings as well as inner and outer rings) shall be capable of meeting...
ASME 2022-09-27 1