Abstract： ASME B16.23:2016 pdf download.Cast Copper Alloy Solder Joint Drainage Fittings: DWV. 10.3 Ovality Maximum ovality shall not exceed l’, of the masimum diameters shown in Table 2 or Table 1-2. The average of the maximum and minimum diameter...

ASME B16.23:2016 pdf download.Cast Copper Alloy Solder Joint Drainage Fittings: DWV.

10.3 Ovality

Maximum ovality shall not exceed l’, of the masimum diameters shown in Table 2 or Table 1-2. The average of the maximum and

minimum diameters shall be within the dimensions shown in the table.

10.4 Alignment

The maximum allowable variations in the regular alignment of all openings shall be 5mm/rn (0,06 in./ft).

10.5 GagIng of Solder loint Ends

(a) Standard Gaging Method of Solder joint Ends. The standard method of gaging the diameter tolerances for male and female ends

shall be by the use 04 plain plug and ring gages designed to hold the product within the limits established in Table 2 or Table 1-2.

(b) Optional Gaging Method of Solder lOOtS Ends. For gaging the diameter tolerance of male and female ends, the manufacturer may

use direct reading instruments instead of ring and plug gages as specified in (a). When gaging the diameters of male and female

ends, using direct reading instruments. refer to para. 10.3.

11 THREADED ENDS

11.1 General

Threaded ends shall conform to the dimensional requirements contained within Table 3 or Table 1-3. Fitting threads shall he

right-hand, conforming to ASME BI .20.1. They shall be taper threads (N1’l’) except for slip joint ends, which shall have

straight pipe threads (NPSM).

Recommended：