ASME B16.50:2021 pdf download.Wrought Copper and Copper Alloy Braze-Joint Pressure Fittings. 10.1 Countersink or Chamfer All Internal threads shall be countersunk a distance no less than one-half the pitch of the thread, at .in angle of app...
ASME 2022-09-27 1
ASME B16.50:2018 pdf download.Wrought Copperand Copper Alloy Braze-Joint Pressure Fittings. The maximum allowable deviation In the angular alignment olany end from the specified axis position shall be 4 deg (1 deg total) (see Figure 11-1)....
ASME 2022-09-27 1
ASME B16.49:2017 pdf download.Factory-Made, Wrought Steel, Buttwelding lnduction Bends for Transportation and Distribution Systems. 6 MATERIAL FOR BENDS CONTAINING WELDS 6.1 LongitudinaL WeLd Seams 6.1.1 Seam welds in pipe made to an API. A...
ASME 2022-09-27 1
ASME B16.49:2012 pdf download.Factory-Made,Wrought Steel, Buttwelding InductionBends for Transportation and Distribution Systems. 3 SIZE The diameter of bends shall be identified by the nominal pipe size (NPS) as defined in ASME B36.lOM (e....
ASME 2022-09-27 1
ASME B16.49:2007 pdf download.Factory-Made,Wrought Steel, Buttwelding InductionBends for Transportation and Distribution Systems. 1.6 Codes and Regulations A becid used under the jurisdiction of a referencing code or governmental regulation...
ASME 2022-09-27 1
ASME B16.48:2005 pdf download.Line Blank. 4 DIMENSIONS 4.1 General Dimensions shall be in accordance with Tables I through 18 (Tables Al through A-iS of Nonmandatory Appendix A). 4.2 Tolerances 4.2.1 FacIng Tolerances. Tolerances for facing...
ASME 2022-09-27 1
ASME B16.50:2001 pdf download.WROUGHT COPPERAND COPPER ALLOY BRAZE-JOINT PRESSURE FITTINGS. 9.2 Ovality of Fining End (C or FTG) Maximum ovality of the titling bra c-joint end shall not exceed l of the maximum diameters shown in Table 3 (Ta...
ASME 2022-09-27 1
ASME B16.40:2002 pdf download.MANUALLY OPERATED THERMOPLASTIC GAS SHUTOFFS AND VALVES IN GAS DISTRIBUTION SYSTEMS. In addition, cvidencc shall be presented to dcinonstrate that such materials will perform satisfactorily in fuel gas as liste...
ASME 2022-09-27 1
ASME B16.39:2019 pdf download.Malleable lron Threaded Pipe Unions Classes 150,250, and 300. 11 AIR-PRESSURE TEST Assembled unions selected In accordance with section 12 shall be tested with air at a minimum pressure of 2.8 bar (44) psi). 12...
ASME 2022-09-27 1
ASME B16.36:2020 pdf download.Orifice Flanges. Changing the distance from the bce or the flange to the tap centerline may also be accomplished by changing the raised face height. If flat gaskets are being used and the raised face is complet...
ASME 2022-09-27 1