AS 3856.1:2021 pdf download

From:Internet 2022-10-01 18:32

Abstract: AS 3856.1:2021 pdf download.Hoists and ramps for people with disabilities-Vehicle mounted Part 1: Product requirements. 1.3.7 inner roll stop barrier located at the interface between the platform and the vehicle 1.3.8 isolation switch devic...

AS 3856.1:2021 pdf download.Hoists and ramps for people with disabilities-Vehicle mounted Part 1: Product requirements.

1.3.7

inner roll stop

barrier located at the interface between the platform and the vehicle

1.3.8

isolation switch

device which isolates an electric circuit from the source of power

1.3.9

lifting cycle

raising and lowering of the appliance through its complete range

1.3.10

outer roll stop

barrier or barriers located at any of the access/egress edges of the platform

1.3.11

platform

load-bearing surface which is constructed in the one plane

1.3.12

ramp

sloping surface joining two different levels which is either permanently or temporarily attached to the vehicle

Note ito entry: A ramp may be made up of two or more sections loined together.

1.3.13

safe working load

swL

maximum load that an appliance is designed to lift or carry as specified by the manufacturer

1.3.14

single fault condition

condition for which a single means for reducing a risk is defective or a single abnormal condition is present

1.3.15

store

move an appliance from an operating position to a stored position on or in the vehicle

1.3.16

vehicle

motor vehicle as defined in the Road Vehicle Standards Act 2018 not including a vehicle exclusively used on a railway or tramway

2 Types of appliances

The following types of appliances are referred to in this Standard:

(a) A platform which is required to be raised and lowered under load. The platform is deployed, stored, raised, and lowered by

power or gravity, or by a combination of these means.


Recommended:

Download Address
Related Standards