Abstract： ASME B5.35:1983 pdf download.Machine Mounting Specifications for Abrasive Discs and Plate Mounted Wheels. 3.6 Projectmg stud type discs (see Table 4 and Fig. 4) are those having studs enclosed in the mounting side of the disc which are loca...

ASME B5.35:1983 pdf download.Machine Mounting Specifications for Abrasive Discs and Plate Mounted Wheels.

3.6 Projectmg stud type discs (see Table 4 and Fig. 4) are those having studs enclosed in the mounting side of the disc which are

located in a pattern to match the corresponding holes in the machine face plate.

3.7 Cylinder type discs (see Table S and FIg. 5) are similar in shape to Type 2 abrasive wheels. Mounting may be by means of inserted nuts, projecting studs, or tapped mounting plate. The mounting means are located in a pattern to match the corresponding holes

in the machine face plate.

3.8 Plate mounted wheels (see Tables 6 and Fig. 6) are bonded abrasives having mounting plates of steel or other rigid material

cemented to the mounting side of the wheel which has mounting holes located in a pattern to match corresponding holes in the

machine face plate. The mounting holes are always located within the inside diameter of the abrasive section. Grinding is done on

the exposed flat side.

4 STANDARD HOLE SPACING FOR STEEL WHEELS (MACHINE FACE PLATES) FOR 10 in. TO 30 in. DIAMETER ABRASIVE

See ANSI B7. 1, American National Standard Safety Requirements for the Use, Care, and Protection of Abrasive Wheels, Table 2.

Minimum Thickness of Machine Face Plates (Steel Disc Wheels) for Mounting Abrasive Discs.

Recommended：