Abstract： ASME B107.110:2019 pdf download.Socket Wrenches,Handles, and Attachments. 4.1.6 UniversaL Joint Sockets (Category 1, Category Z and Category 34). Universal joint sockets shall consist of a single- (6-point) ordoublc-hcxdgon (12-point) socke...

ASME B107.110:2019 pdf download.Socket Wrenches,Handles, and Attachments.

4.1.6 UniversaL Joint Sockets (Category 1, Category Z and Category 34). Universal joint sockets shall consist of a single-

(6-point) ordoublc-hcxdgon (12-point) socket and an intcrnal drive end. Each member shall be permancntly attached to each other or by means of an Intermediate member to form a universal joint. The sockets shall be provided with a means to hold the drive end and socket end in any set position with a force adequate to hold the socket against gravity. For universal sockets with square block

joints, angular deviation from the centerline is 40 deg minimum. For universal sockets with ball-swivel joints, angular deviation

from the centerline is 20 deg minimum to 35 deg maximum. If hinge pins are used, they shall not extend beyond the periphery of the universal joint section by more than 0.031 in. (0.79 mm) and shall not interfere with the regular operation of the universal

joint. The portion of the hinge pin that extends beyond the periphery shall not have sharp edges.

4.2 DesIgn — Category 2

4.2.1 Type land Type VII Sockets, Single Hexagon (6- Point) and Double Hexagon (12-Point) and Type II Sockets, Single Square

(4-Point) and DoubLe Square (8-Point). Sockets shall be sinillar to Figure 3-1 and shall conform to Table 4.2.1-1 (Table 4.2.1.IM) through Table 42.1-13.

4.2.2 Type Ill — Universal Sockets, Single Hexagon (6-Point) and Double Hexagon (12-Point). Type Ill universal sockets shall be

similar to Figure 3-2 and comply with Table 4.22-l (Table 4.2.2-1M) and Table 4.12-2 (Table 4,2.2-2M).

Recommended：