Abstract： ASME B107.17:2015 pdf download.Gages and Mandrels for Wrench Openings. 4.2 Gage Use and Design The gages shall be of the sizes and tolerances given in Tables 1. 1,2, 2M. 3, and 3M. Formulas are provided for sizes not listed. The gages shall...

ASME B107.17:2015 pdf download.Gages and Mandrels for Wrench Openings.

4.2 Gage Use and Design

The gages shall be of the sizes and tolerances given in Tables 1. 1,2, 2M. 3, and 3M. Formulas are provided for sizes not listed.

The gages shall be used in accordance with accepted practices. Manufadurers may use gages with tighter dimensions than those shown herein.

The size for all limits (GO and NO GO) gages shall not exceed the extreme limits specified herein. All variations (manufacturing tolerance, calibration error, wear allowance, etc.) in the gages, whatever their cause or purpose, shall bring these gages within the extreme limits of this gage size specified within this Standard. Thus a gage that represents a minimum limit may be larger. but

never smaller, than the minimum size specified; likewise, the gage that represents a maximum limit may be smaller, but never larger, than the maximum size specified.

4.2.1 Rounding Method. Rounding method is to be used for determining dimensions for gages When the next digit beyond the last

digit to be retained is

(a) less than 5, the last digit to be retained is not changed

(b) 5 or more, the last digit to be retained is increased by one

4.3 Mandrels Use and Design

4.3.1 Mandrels log Nut End Socket Openings. The hexagon mandrels shall be of the size and tolerances given in Tables 4 and 4M. The square mandrels shall be of the size and tolerance given in Table 5. The mandrel shall be inserted into the nut end socket opening to the depth indicated in the applicable table.

4.3.2 Mandrels for Wrench Openings. The hexagon mandrels shall be of the size and tolerances given in Tables 4, 4M, and 5. The

mandrel shall be fully engaged to the thickness of the wrench head.

Recommended：