Abstract： ASME B107.11:2002 pdf download.PLIERS: DIAGONAL CUTTING AND END CUTTING. 6.2.2 Steel Wire Cut Test fo Types I, II, and UI. Three cuts shall be made at the 1oint end of the cutting edges. and the load required to completely sever the wire sh...

ASME B107.11:2002 pdf download.PLIERS: DIAGONAL CUTTING AND END CUTTING.

6.2.2 Steel Wire Cut Test fo Types I, II, and UI. Three cuts shall be made at the 1oint end of the cutting edges. and the load

required to completely sever the wire shall not exceed the maximum handle load. Load shall be applied at the point of maximum

handle curvature (normal gripping position)

623 Steel Wire Cut Test for Type IV. A total of nine cuts shall be made. Three cuts shall made at the approximate midpoint of the

cutting edges, and the test load required to completely sever the wire shall not exceed the maximum handle load. Three cuts shall

be made at each end of the cutting edges with the wire located not more than 0.13 in. (33 mm) from the respective cnds. Load shall be applied at the point of maximum handle curvature (normal gripping position). Load determinations shall not be required for cuts made at the ends of the cutting edges.

6.2.4 Paper Cut Test. Foflowing wire cut test, the paper cut test shall be performed per ASME B107.25M, para. 5.2.2. The cutting

edges shall completely and cleanly cut bond paper. Load shall be applied at the point of maximum handle curvature (normal gripping position).

6.3 Hardness Test

Hardnes.ses specified herein shall be tested in accordance with ASME 510725M. pars. 53. Handle hardness determination shall be

taken approximately midway between the fastener and the end of each handle.

Recommended：